Parametric Thrust Bearing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully Parametric Thrust Bearing with included .f3d
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 233
- Wydruki
- 1
- Wyświetlenia
- 1520
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a fully parametric 3d-printable thrust bearing cage, using cheap ball bearings to provide reliable motion. I needed a thrust bearing in a weird ID/OD combination for a low-load situation, and couldn't find anything reasonably priced off-the-shelf. Total parts cost for the attached size is <$4 including filament.
The model parameters can be adjusted to change:
- Inner diameter
- Outer diameter
- Total thickness
- Tolerances
- Ball bearing size
The attached STL is a 40mm ID/110mm OD, using 36 ¼ inch ball bearings. The balls are a press-fit into the bottom part of the cage, and are fully retained once pressed in, while still being able to rotate freely.
I used PLA to print these, due to its stiffness over PETG. 0.2mm layer height is plenty of detail for the radii in the bearing cages.