1 / 8
Modular Hydroponics — zdjęcie 1
1 / 8

Modular Hydroponics

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

My first attempt at a modular hydroponic system

Ocena
0 / 5
Polubienia
14
Pobrania
114
Wydruki
0
Wyświetlenia
878
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is my first attempt at a modular hydroponics.

Made the sections so that you can connect them in a modular fashion. 

Printed using PETG:
- 4 top and bottom layers, 4 perimeter layers
- 25% infill

Baskets:

https://www.amazon.ca/gp/aw/d/B07W9H8ZRH?psc=1&ref=ppx_pop_mob_b_asin_title

Pump:

https://www.amazon.ca/dp/B01NBPCVW3?psc=1&ref=ppx_yo2ov_dt_b_product_details
- DONT use a high flow pump as it will likely cause sections to overflow

To connect individual parts I used plumber's tape over the outlets as well as a short section of ½ inch vinyl tubing (about 3cm). 

I ran out of 1/inch vinyl tubing so I improvised and used some old garden hose as my drainage pipes at the end (see photo)

Tinkering with this in my spare time and learning how to use Onshape.

Open to any advise / suggestions to improve.

Tagi