1 / 3
V0 Minimalist 130 degree Print Cam (using Pi Cam Clone) — zdjęcie 1
1 / 3

V0 Minimalist 130 degree Print Cam (using Pi Cam Clone)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A camera mount for Voron 0 using a Pi Clone camera module

Ocena
0 / 5
Polubienia
19
Pobrania
71
Wydruki
0
Wyświetlenia
734
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

This is a cheap and effective webcam for the Voron V0. The module only costs ~$5, cable a few dollars and the result is excellent.

I remixed the one by SvB to create more clearance for the longer leadscrew on my Moons Motor (included in the formbot kit).

Highly recommend doing this mod. For those going bare bones and believing they'll get closer to the centre… you won't… and this mod actually makes things look nice!
 

BOM

1 x 3mm hex or square nut

1x 6mm M3 bolt

1x 130 Deg OV5647 Camera Module https://www.aliexpress.com/item/1005003386791483.html  

1x 30cm Ribbon Cable
https://www.aliexpress.com/item/32845380904.html

Install

The best place to thread the ribbon cable is through the top of the back cover. The nut/screw will easily slide into the z axis extrusion. Suggest loosening screws on back panel and not tightening until install is complete. With these ribbon cables you slide the clasp back, insert the ribbon and then slide in place again. My cable was find flex back against itself and up through the top of the panel.

Before you screw it all in, check your lead screw clears the camera and that you anti-backlash nut also clears the camera module. This camera is aiming to be as close to the bed as possible and so you may want a spacer for the springs to ensure this. I used this spacer on my kirigami.

Once you're hooked into the raspberry pi you have a little bit of work to do for setting up this webcam. From the command line run: sudo raspi-config and then Select Interface => Enable Camera

The setup process in Mainsail/Klipper for me wasn't straightforward for this particular camera and so I'll leave here the guides that helped me.

https://crowsnest.mainsail.xyz/faq/upgrade-from-v3-to-v4 for crowsnest.

https://crowsnest.mainsail.xyz/faq/how-to-setup-a-raspicam (the second trouble shooting section finished it off for me. 

Tagi