1 / 2
Structural formula adrenaline as LED neon light
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you are a chemist, you will love it.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 251
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyPliki (16)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (8)Powiązane
Work steps
- Parts printing
- Connector 1 you need six and connector 2 three times.
- Assemble parts. Best on a suitable table. Needs some space.
- Insert cable. Leave some overhang so that you can shorten it when the LED strip is inserted.
- Fill the longest possible path with the LED strip.
Cut the rest and solder it. - Check in between that all solder joints have contact.
- Hang up and enjoy
Hints
- I tried to solder the cables so that they go straight down into the cable channel. Then the bending radius is smaller. I have also torn off soldered joints. Do not make the temperature on the soldering iron too hot.
- In the double bindings, I have installed undercuts so that the cable has enough space. In the pentagon is a tunnel in the webs so that the cable can be fed through. With a little patience, it works.
- Make the calves longer than they really need to be. Do not cut them to course. Only shorten if you also want to solder dise.
- I have hung the lamp with two headless nails.
Tools you will need:
- LED-Strip
- Soldering iron
- Solder
- Cable 0,25 mm²
- Side cutter
- Needle nose pliers
- pad for soldering
- Knife/ scalpel
- wire stripper
I printed it on 0.2 speed with a 0.4 mm nozzle. You don't need to adjust support. You will need to remove some filament from the connector holes.
Print time 16:50h
61.3 cm x 54.3 cm size