1 / 6
Sony E-Mount 1.25" Telescope Adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For mounting a Sony E-Mount camera to a 1.25" telescope eyepiece tube
- Ocena
- 4,667 / 5
- Polubienia
- 80
- Pobrania
- 785
- Wydruki
- 5
- Wyświetlenia
- 3006
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 5) (Komentarze: 8)Remiksy (1)Kolekcje (91)Powiązane
Single-piece adapter for mounting a Sony E-Mount camera to a 1.25" tube.
Thanks to this model/designer for the e-mount geometry.
Designed for and tested with a Sony a6000 and Celestron NexStar 5SE, but should work with most E-Mount cameras and telescopes with 1.25" optics.
Tips/Settings:
- PETG recommended, though I'm sure PLA would work fine
- Take advantage of variable layer heights to reduce print time (e.g. the main tube is just a plain cylinder, which can use a larger layer height. But the fitting should be as precise as possible)
- Print with the tube face down (as positioned in the file)
- Supports should not be needed
- Use ironing to make the surfaces that mate against the camera as smooth as possible. And/or sand it to a smooth finish
- Post-processing: Be sure to thoroughly clean up any stringing, dangling bits of filament, etc. You don't want little pieces of plastic getting into your camera or telescope optics
See gcode/3mf for my print settings. I used black PETG Prusament.