1 / 6
Sony E-Mount 1.25" Telescope Adapter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For mounting a Sony E-Mount camera to a 1.25" telescope eyepiece tube
- Rating
- 4.667 / 5
- Likes
- 80
- Downloads
- 785
- Makes
- 5
- Views
- 3,006
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution
Single-piece adapter for mounting a Sony E-Mount camera to a 1.25" tube.
Thanks to this model/designer for the e-mount geometry.
Designed for and tested with a Sony a6000 and Celestron NexStar 5SE, but should work with most E-Mount cameras and telescopes with 1.25" optics.
Tips/Settings:
- PETG recommended, though I'm sure PLA would work fine
- Take advantage of variable layer heights to reduce print time (e.g. the main tube is just a plain cylinder, which can use a larger layer height. But the fitting should be as precise as possible)
- Print with the tube face down (as positioned in the file)
- Supports should not be needed
- Use ironing to make the surfaces that mate against the camera as smooth as possible. And/or sand it to a smooth finish
- Post-processing: Be sure to thoroughly clean up any stringing, dangling bits of filament, etc. You don't want little pieces of plastic getting into your camera or telescope optics
See gcode/3mf for my print settings. I used black PETG Prusament.