Spare Nozzle Case V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
UPDATED VERSION I designed this case to hold my spare nozzles for my Prusa i3.
- Ocena
- 4,4 / 5
- Polubienia
- 39
- Pobrania
- 217
- Wydruki
- 7
- Wyświetlenia
- 1128
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
UPDATED VERSION
I designed this case to hold my spare nozzles for my Prusa i3. The case is printed in one piece with functional hinge and clip to keep the case closed when not in use. Never mislay those nozzles again. This one has text 'Nozzles 0.4mm' let me know if you would prefer one that just says 'Nozzles' or blank and i will add additional versions.
This version uses less supports as the top is printed directly off the build plate so only support required is for the hinge.
STL 'Nozzle_Case_Nozzles_Text.stl' = Top With text reading 'Nozzles'
STL 'Nozzle_Case_0.4Text.stl' = Top With text reading 'Nozzles 0.4mm'
STL 'Nozzle_Case_Blank_Top.stl' = Blank Top
Print instructions
Category: 3D Printing Summary
UPDATED VERSION
I designed this case to hold my spare nozzles for my Prusa i3. The case is printed in one piece with functional hinge and clip to keep the case closed when not in use. Never mislay those nozzles again. This one has text 'Nozzles 0.4mm' let me know if you would prefer one that just says 'Nozzles' or blank and i will add additional versions.
This version uses less supports as the top is printed directly off the build plate so only support required is for the hinge.
STL 'Nozzle_Case_Nozzles_Text.stl' = Top With text reading 'Nozzles'
STL 'Nozzle_Case_0.4Text.stl' = Top With text reading 'Nozzles 0.4mm'
STL 'Nozzle_Case_Blank_Top.stl' = Blank Top
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
</div>Rafts:No
Supports:
Yes
</div>Resolution:0.2mm
Infill:
10%
</div>Notes:
There will be a tiny bit of support that prints in the clip between the top and little notch which is used on the clip into the bottom half of the case which if you forget to remove could potentially cause the clip to snap, but as i've always removed that i've not had that happen to me personally.