Mk3S+ angled heat bed cable cover (Expanded)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Angled heat bed cover for easier fitting inside enclosures. Longer grab area ensures the fabric sleeve is secure.
- Ocena
- 4,167 / 5
- Polubienia
- 47
- Pobrania
- 398
- Wydruki
- 5
- Wyświetlenia
- 1277
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Post a make if you print! I would love to see it.
Changelog
9th June 2024 - Added more room on the inside for the eye terminals and the cables to loop around in as a comment stated they couldn't get theirs to fit.
8th June 2024 - Added cutouts on the top half part to give more room for the screws on the heat bed as someone stated that they had clearance issues with them.
Works with original hardware.
I downloaded an angled heat bed cover clip to fit my Mk3s+ in a LACK enclosure without pinching the heat-bed cable on the rear of the enclosure when the Y axis moves back. When I installed it there was not enough room where the clip grabbed the cable to properly grab the fabric sleeve, and so the sleeve kept falling out of it, meaning the wires were hanging unsupported from the clip.
My version adds about 5mm to the part that grabs the cable in order to hold it securely. It is a remix however I unfortunately now cannot find the model I originally downloaded to add it under the remixed model section.