1 / 4
BoomRacing BRX02 Series II & III Radiator — zdjęcie 1
1 / 4

BoomRacing BRX02 Series II & III Radiator

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a cover to hide the motor of your BoomRacing BRX02 Series III behind the grille.

Ocena
0 / 5
Polubienia
20
Pobrania
255
Wydruki
0
Wyświetlenia
1060
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

EDIT 12/12/23: I added a 36mm version with other writing on the front.

EDIT: I added a 37mm version for Spektrum 2 in 1.

I made this model to hide the motor of your BoomRacing BRX02 Series III that is visible thru the grille. 

This radiator is specifically for a Hobbywing Fusion SE, which has a diameter of 36mm. The radiator is friction fitted so no need for glue, if you prefer you can also use some double sided tape, but this is certainly not needed.

There is an opening for the cables of the motor, it is possible that you will need to reposition the motor to make the model fit if you installed it with the cables to a different direction.

Clearance for the servo is no issue.

Please note that this model will only fit motors with a 36mm diameter! 

Print settings:

  • PLA
  • 0.2mm layer height
  • 15% infill is more than enough
  • No need for supports, if printed face down. I advise to change the angle of the bridging infill so that the bridging infill is square on the long lines on the face.

I would appreciate a like on the model if you download it and a make once you printed it.

Feel free to reach out to me if you want a model with a different diameter.

 

Tagi