Ender 3 Neo Series Default Fan Shroud ( For Ender 3 Neo, Ender 3 V2 Neo, Ender 3 Max Neo )
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Default Fan Cover Replacement Shroud.
- Ocena
- 4,833 / 5
- Polubienia
- 78
- Pobrania
- 488
- Wydruki
- 7
- Wyświetlenia
- 4540
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I made and tested it for my Ender-3 V2 Neo, but should work with all Neo Models as they use the same hotend setup.
In my case, it increased airflow and decreased some noise too.
The weight is also drastically decreased over the default enclosure.
.
Layer Height: 0.2
Material: Works with PLA and PLA+, (Just For Precaution Recommended PETG)
Supports are needed as shown in the picture.
Keep the orientation as shown for a neat outer finish.
Block the supports as shown in the red shade in the picture as that area doesn't need them.
You can scale the model in the Shroud-body direction for up to 10%.
Place the Z-Seam as shown in the picture with a blue line to make the visible part clean.
.
The file is slightly modified than in the pictures and will work better even better than my setup.
Don't forget to save the screw from the original setup used to fasten the original enclosure and even the one used to mount the fan to the original enclosure.
Beware of transferring the default fan into this new shrout as the wires are quite delicate and may unsolder themselves as it happened to me. :'')
Happy Printing.