TrayNeko60 60% keyboard case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix from Bakeneko 60 V3 case to turn it in to tray mount
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 116
- Wydruki
- 0
- Wyświetlenia
- 1033
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- GNU General Public License v3.0
I turned bakeneko60 case to have mounting points for tray mount PBCs.
There are lots of different cases for 60% tray mount but I didn't enjoy them or they didn't fit my print bed. This model fits 300x300 bed.
This was mainly made for my lumberjack that only uses 3 mounting points but I also made “standard” 60% version to support other PCBs.
Only lumberjack heat-inserts version is printed and tested. The usb-c fit was very tight and I had to use crafting knife to make it little bit more bigger. I have updated the models have 0.1 offset around the usb-c hole but keep that in mind that fit might be still too tight.
Heat-inserts that I used are M2x4x3.5: https://vi.aliexpress.com/item/1005004074135441.html
I recommend M2x5 screws as I designed screw holes 4mm deep and pcb normally is 1.6mm or 1.2mm.
USB-C hole location is based so that it is on backside of the pcb!
You can check the original step file from here under the case folder: https://github.com/kkatano/bakeneko-60
You can check more information of lumberjack keyboard from here: https://github.com/peej/lumberjack-keyboard