TrayNeko60 60% keyboard case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix from Bakeneko 60 V3 case to turn it in to tray mount
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 116
- Makes
- 0
- Views
- 1,033
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- GNU General Public License v3.0
I turned bakeneko60 case to have mounting points for tray mount PBCs.
There are lots of different cases for 60% tray mount but I didn't enjoy them or they didn't fit my print bed. This model fits 300x300 bed.
This was mainly made for my lumberjack that only uses 3 mounting points but I also made “standard” 60% version to support other PCBs.
Only lumberjack heat-inserts version is printed and tested. The usb-c fit was very tight and I had to use crafting knife to make it little bit more bigger. I have updated the models have 0.1 offset around the usb-c hole but keep that in mind that fit might be still too tight.
Heat-inserts that I used are M2x4x3.5: https://vi.aliexpress.com/item/1005004074135441.html
I recommend M2x5 screws as I designed screw holes 4mm deep and pcb normally is 1.6mm or 1.2mm.
USB-C hole location is based so that it is on backside of the pcb!
You can check the original step file from here under the case folder: https://github.com/kkatano/bakeneko-60
You can check more information of lumberjack keyboard from here: https://github.com/peej/lumberjack-keyboard