FLSUN Super Racer (SR) USB side lights holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An holder to have practical USB light sticks on the side columns of the SR.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 679
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Practical, easy.
I already put a “selfie led circle” on the top of the printer but that wasn't enough light for my uses. Then i discovered those nice USB led strips, so i did some holders for them to put on the inner sides (left and right) of the SR columns.
You will need 2 USB led sticks (they are avaiable in the formats i show in the picture, but i strongly advise you to get the “medium” ones), you can get them in cold or warm white.
Then, 2 female USB A connectors (only +5v and GND).
Or course you will also need to provide 5 volts to the led sticks, so a buck converter, some cables and soldering skills are mandatory.
Maybe an on/off switch (to put in the rail between the 24V and the buck converter) will be useful.
If you don't know what you're doing, don't do anything: i take no responsability for any damages you can get.
The model can be printed without any support, PLA or PLA+ (or whatever) with minimal infill; just print 2 of them, slide the USB connector in them and put them in place (just insert them in the rails with a 30° angle then rotate them to be flat on the printer, they will stick in place in a firm way).