Megacell Charger Battery Shim
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a shim to print and place under your batteries in the Megacell Charger ( Batch 1 and 2 ) ... it prevents 18650…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 333
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a shim to print and place under your batteries in the Megacell Charger ( Batch 1 and 2 ) ... it prevents 18650 cells from rocking and making bad contact due to the small temperature sensor that is located just under the cell.
No need to glue or tape into place... just drop into the slot and it should stay in place by itself.
Print instructions
Category: Parts Summary
This is a shim to print and place under your batteries in the Megacell Charger ( Batch 1 and 2 ) ... it prevents 18650 cells from rocking and making bad contact due to the small temperature sensor that is located just under the cell.
No need to glue or tape into place... just drop into the slot and it should stay in place by itself.
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 6
</div>Rafts:No
Supports:
No
</div>Resolution:0.3
Infill:
20%
</div>Filament:
eSun PETG Grey
Notes:
You can use any material -- but I use PolyCarbonate or PETG. PLA/PLA+ works, but beware that at higher temperatures ( >60C ) it gets soft.