1 / 3
Press Lube Packer for LM20UU 20mm Linear Bearings — zdjęcie 1
1 / 3

Press Lube Packer for LM20UU 20mm Linear Bearings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A two-piece pressing grease/lube packer for LM20UU, an easy and efficient way to pack these big bearings.

Ocena
0 / 5
Polubienia
7
Pobrania
18
Wydruki
0
Wyświetlenia
441
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

    I needed a way to lube my new bearings, and hopefully without making a huge mess and wasting allot of lube. 

    So, I made this with the idea that if I had two solid parts that pressed together. I wouldn't waste any leftover lube inside the printed part. and you could get a much higher pressure than you could with squeezing a tube.

 

    Usage Directions.

  1. All you need to do is put one of the pieces into the bearing and then set it down, printed part down, onto a flat surface. 
  2. Put some lube into the center of the bearing, you can repeat this process multiple times so you can start will a little bit of lube if you dont know how much you need.
  3. Then insert the second piece into the bearing from above and press down intil some of the lube starts to leak out of the bearing. Repeat step 2 if you go all the way down without any leakage. 

Tagi