1 / 2
Easy to Print/Use Paper Towel Holder (Remix) (w/ & without locking mechanism) — zdjęcie 1
1 / 2

Easy to Print/Use Paper Towel Holder (Remix) (w/ & without locking mechanism)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remixed, improved version of the easy to print paper towel holder by @BlueBaron37 Also, now with locking mechanism!

Ocena
5 / 5
Polubienia
13
Pobrania
60
Wydruki
2
Wyświetlenia
902
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

Remixed version of the “Easy to Print/Use Paper Towel Holder” V2 model, focused on better, softer looks and easier usage. The original model works quite fine, but is a bit “rough” to my taste, and the tolerances were not achieveable on my printer, so I recreated the model (while learning OnShape) and made some adjustments.

Also, now with locking mechanism!

Update (2023-07-24):

  • Added "variant with stoppers" - a simple locking mechanism which prevents accidentally sliding out of the arm from the rail.

Main changes (vs original model):

  • V1, with stoppers variant
    • Added stoppers (locking mechanism) on the connector & rail system
      • Two small protrusions on the arm's connector
      • Two small grooves in the rail's dovetail
      • Small gutter which directs the protrusions when sliding in
  • V1, both variants:
    • Introduced filets for better smoothness where it matters (mostly on the arm)
    • Slight dimensional changes
      • Slightly thicker arm (8mm)
      • Slightly shorter towel tube (45mm)
      • Longer rail (40mm)
    • Added adhesive groove on the top part of the rail
      • 0.3mm extrusion for your VHB / PowerTape strip
    • Improved arcs smoothness
      • Original model had low arc resolutions on the tube, leading to choppy towel holder
    • Dovertail-shaped rail-to-arm connector
    • Introduced less strict tolerances for rail-to-arm connector
      • 0.3mm tolerance
      • Please note that for well tuned and accurate printers this might degrade how well the arm sits in place
        • I'm also testing a version with small protrusions which should lock the arm in place, while keeping tolerances relaxed for ease of printing, stay tuned
    • Face blend between arm's connector and arm's main surface
      • Slightly improved bendiness of the arm

Print parameters:

  • Material: PETG (PLA should be fine as well)
  • Layer height: 0.2mm
  • Perimeters: 2 (or more to improve bendiness even further)
  • Infill: 15% gyroid

Changelog:

  • 2023-07-23
    • V1 (basic) released
  • 2023-07-24
    • V1 (with stoppers) added

Tagi