Add-on Sections for @pittance's Wind Tunnel Desk Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made a tailcone section to fit the Noctua NF-a12x25 to @pittance's wind tunnel and a test section to fly a little wing.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 251
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Other needed parts here, https://www.printables.com/model/258117-wind-tunnel-desk-fan-fan-v5-pc-120mm
Normalish print settings, supports needed here and there.
Print the wing, shaft and block as light as possible, one perimiter, no infill, a light filament. I used PLA-CF. Small parts here out of necesity, a bit of sanding, and I glued one troublesome block onto the shaft.
Wing stayed flying for me if I helped it into the air first. (Noctua NF-a12x25 with my https://www.printables.com/model/299994-xj99c-noctua-nf-a12x25-mod , but probably many better options. A 3000 RPM fan would do some fun things, I think).
If you go with the windows, maybe you can get them clearer than mine.
Smoke visualizations here,