1 / 6
Case for FrSky RX6R receiver
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a minimalist case for the FrSky RX6R. Two versions are provided, with/without access to the S-Port socket.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 80
- Wydruki
- 1
- Wyświetlenia
- 829
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a minimalist case for the FrSky RX6R. Two versions are provided, one with access to the S-Port socket (as shown), and one without.
The case fits receivers with PWM ports and bind button on the same side of the board (this is the most common arrangement).
Instructions:
- Remove the card wrapper from receiver, cut a piece 21 x 18 mm - this will be the new bed
- Print the case
- Lay the bed (from step 1) inside the bottom half
- Place the rx board over the bed
- Locate the top half and secure with tape or cyano
- Apply hot glue to the antennae exits
See screenshot for Cura slicer settings.
See also my case for the G-RX6.
Print Settings
Printer Brand:
Creality
Printer:
CR-10 Mini
Rafts:
Doesn't Matter
Supports:
No
Infill:
Use default (not critical)
Filament:
Category: Models