Arducam UC-684 Camera Mount for Voron Printers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A camera mount for the Arducam IMX291 Camera to mount to the top extrusions on Voron 2.4 and Voron Trident printers.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 164
- Wydruki
- 0
- Wyświetlenia
- 1131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a mount for the Arducam IMX291. I purchased the camera from Amazon here. The parts consist of a back cover, front cover, and a mount. 2 mounts are included. One mounts in the corner of two 2020 extrusions and one mount is for mounting flat against a 2020 extrusion. It was designed and works with the camera linked here. YMMV on other cameras.
The cover takes 4 M3 heatset inserts. The mount takes one M3 heatset insert. Use 4 M3 x 6mm SHCS for the covers, 1 M3 x 14 SHCS for the mount pivot, and 2 M3 x 8mm SHCS for mounting the mount to the extrusion using M3 t-nuts.
BOM:
- 5 - M3 Threaded Inserts (M3x5x4)
- 4 - 6mm M3 SHCS
- 2 - 8mm M3 SHCS
- 1 - 14mm M3 SHCS
- 2 - M3 T-nuts
The models print without generated supports. Print the front cover with the front face down on the bed. The rear cover has built-in supports that should break away easily. It should be printed with the inside part of the cover down on the bed. The mounts should print with their flat side on the bed.