IKEA Trofast Baseplates for Gridfinity
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity Baseplates for IKEA Trofast containers.
- Ocena
- 4,5 / 5
- Polubienia
- 63
- Pobrania
- 274
- Wydruki
- 3
- Wyświetlenia
- 3459
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Note: Recently found that some Trofast are a little smaller. Have designed slightly smaller and will print and retest before I post.
Girdfinity baseplates to fit inside IKEA Trofast containers. I use these with brackets I made as drawers for Kallax storage.
The original baseplates I built from had 6mm models for magnets. I could not get 6mm magnets in. So I made plates with 6.1mm and 6.2mm holes for press fit and glue in. I fine tune with X-Y hole compensation.
Print two of Left and Right to make a full set. I use 4 screw inserts for each of one side, then bolts from the other side. So if you insert on the Lefts only, all will work together. See photos for more info.