QYSEA FIFISH Robotic Arm cutting claw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
QYSEA FIFISH ROV Robotic Arm cutting claw (integrated recessed blade) for cutting vegetation, ropes and small wire
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 209
- Wydruki
- 2
- Wyświetlenia
- 1335
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed a cutting claw with integrated recessed blade for cutting vegetation, ropes and small wire with the underwater QYSEA FIFISH ROV + Robotic Arm. I don't have yet an underwater drone but they amazed me. Will get a FIFISH soon!
Here is my contribution to the community:
DIN7981 tapping screws
2x d 2.9mm x L 13mm (https://amzn.to/3WgKty1)
1x d 2.2mm x L 13mm (https://amzn.to/3LYQ7Ah)
1x trapezoid blade 52mm x 19mm x 0.5mm (https://amzn.to/45XhZxw)
I may earn a commission on qualifying purchases (at no extra cost to you)
I printed the claw with Prusament PETG, 100% infill, 0.3mm layer height in DRAFT mode. No supports needed. Depending on your filament and settings you might need to use a small nail-file on the notch of the "cutting_claw_notch.3mf". Clean it up a little bit so the blade can enter the notch.
Caution: Be careful and avoid cutting your ROV tether cable ;-)