QYSEA FIFISH Robotic Arm cutting claw
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
QYSEA FIFISH ROV Robotic Arm cutting claw (integrated recessed blade) for cutting vegetation, ropes and small wire
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 209
- Makes
- 2
- Views
- 1,334
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed a cutting claw with integrated recessed blade for cutting vegetation, ropes and small wire with the underwater QYSEA FIFISH ROV + Robotic Arm. I don't have yet an underwater drone but they amazed me. Will get a FIFISH soon!
Here is my contribution to the community:
DIN7981 tapping screws
2x d 2.9mm x L 13mm (https://amzn.to/3WgKty1)
1x d 2.2mm x L 13mm (https://amzn.to/3LYQ7Ah)
1x trapezoid blade 52mm x 19mm x 0.5mm (https://amzn.to/45XhZxw)
I may earn a commission on qualifying purchases (at no extra cost to you)
I printed the claw with Prusament PETG, 100% infill, 0.3mm layer height in DRAFT mode. No supports needed. Depending on your filament and settings you might need to use a small nail-file on the notch of the "cutting_claw_notch.3mf". Clean it up a little bit so the blade can enter the notch.
Caution: Be careful and avoid cutting your ROV tether cable ;-)