Battery charger for CRC123A RC123A using TP4056 module
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here is a charger for CRC123A/RC123A batteries, using a TP4056 charging module. I'd printed other models but found…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 405
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Here is a charger for CRC123A/RC123A batteries, using a TP4056 charging module.
I'd printed other models but found them too tight to place/remove the cells, so I designed this, giving more clearance and using springs salvaged from an 18650 module. The module and springs were hot glued.
I stripped the wire to fit through the holes, just to make it more compact and keep the wire flush to the bottom.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10
Filament: eSun PETG Purple
Notes:
I used PETG but PLA would be fine too. Used 10% infill to give the base a bit of rigidity
Category: Electronics