1 / 3
Lerdge iX - Frame for 20 teeth ball bearing Pulley with 3mm shaft — zdjęcie 1
1 / 3

Lerdge iX - Frame for 20 teeth ball bearing Pulley with 3mm shaft

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

New frame for toothed pulley with 20 teeth and ball bearing for 3mm shaft.

Ocena
0 / 5
Polubienia
11
Pobrania
100
Wydruki
0
Wyświetlenia
629
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I had light VFAs on the Y-axis, so I wanted to use a timing belt pulley with ball bearings.
For this, the frame had to be adapted (wider and for 3mm shaft as M3 screw).

At the same time I installed another stepper motor with 0.9 degree steps, which also worked well in my Sovol SV06. The motor is a 1:1 replacement, cables don't need to be changed and it stays cool in operation.

The VFAs are now gone!
However, I unfortunately do not know whether it is now the new pulley or the new stepper motor or both mods ;-)

If you also want to use a 0.9 degree stepper motor, you have to adjust the steps - see picture.

I printed without supports and with 0.12mm layers in Extrudr PETG "neon green".

Tagi