Shock tower brackets for Dukedoks Cramer RC Truggy car
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed these shock tower brackets so you can attach the shocks to the body instead of the upper arm.
- Ocena
- 0 / 5
- Polubienia
- 36
- Pobrania
- 120
- Wydruki
- 1
- Wyświetlenia
- 1598
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed these shock tower brackets so you can attach the shocks to the body instead of the upper arm. This gives the shock more use and more stability.
You can still use the original shocks that were advised in the guide (98mm I think it was). And also the original arms are still usable. Only thing is that the screw+nut push on the upper arm a bit when compressing the shock. Have to think of solution for that in the next version.
You can use the ‘upwards’ bracket if you want your Cramer to have a lower ride height or you're using longer shocks.
I have printed the brackets in PLA and works fine but I haven't crashed yet. Might test TPU in the future though.
Print instructions:
- 0.2mm layer height
- Keep orientation as the models come for increased strength
- Use supports for the ‘bar’ model