Simple Hygrometer Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple, yet decorative, hygrometer stand
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 38
- Wydruki
- 1
- Wyświetlenia
- 193
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple hygrometer holder with fire and snowflake cutouts above the temperature readout and water droplet cutouts below the humidity readout. Fits the standard rectangular LCD hygrometer available many places online. I purchased these in a 4 pack on Amazon.
Prints easily face down with no support needed. The fit is a bit snug, and takes some force to get the hygrometer past the clips into place. After lining it up, I pressed one side all the way through at a time. If you find it too difficult to assemble, you may be able to scale it up slightly to make it easier, but I have not tried this. Enjoy!
Printed in PLA at 100% infill with 3 perimeter walls and monotonic top/bottom order in Cura slicer.