Wera 2go lid holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the Wera 2go toolbox lid that stops is from flapping back.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 502
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I was annoyed that the lid of the Wera 2go toolbox always flaps back as you open it so I designed these two parts which stops it. The body-part clips onto the body of the toolbox and has a tight fit. On the lid piece I sticked a piece of velcro so it holds onto the velcro strip of the lid. For the absorber I used steelwire were i clamped the ends to a loop an covered the clamp with a heat shrink tube but you can also use cord.
I used M3 threaded inserts from CNC Kitchen for better durability but i also uploaded a version for M3 screws with a little bit undersized holes.
For assembly I used 4x M3x10 screws and 2 washers for each screw and glued them in with loctite.