Wera 2go lid holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder for the Wera 2go toolbox lid that stops is from flapping back.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 23
- Makes
- 0
- Views
- 502
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
I was annoyed that the lid of the Wera 2go toolbox always flaps back as you open it so I designed these two parts which stops it. The body-part clips onto the body of the toolbox and has a tight fit. On the lid piece I sticked a piece of velcro so it holds onto the velcro strip of the lid. For the absorber I used steelwire were i clamped the ends to a loop an covered the clamp with a heat shrink tube but you can also use cord.
I used M3 threaded inserts from CNC Kitchen for better durability but i also uploaded a version for M3 screws with a little bit undersized holes.
For assembly I used 4x M3x10 screws and 2 washers for each screw and glued them in with loctite.