Ender 3 V2 Neo with Kingroon Titan E3D V6 direct drive kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
And Ender 3 V2 Neo converted to direct drive with Kingroon Titan and E3D V6 kit.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 1715
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Here an inexpensive E3D V6 clone with Titan extruder in configuration Direct Drive mounted on an Ender 3 V2 Neo.
Let's start from important notes:
to have the pancake stepper work on the Ender 3 V2 Neo the central wires of the stepper must be swapped (see photo);
the VREF voltage of the E stepper has to go from 1.38v to 1v, or the stepper will overheat and fail.
As you can see the X limit switch has been relocated, and needs a 3mm hole drilled just 10mm from back side.
The braket I designed is both for the CR-Touch mount and has an hole for the screw that activate the X limit switch. Print it in PETG because PLA tend to soften with bed heat.
The stock X belt is too short, you have to build a new one.
E-steps needed to be set near 398 +/- 2. Do the E-steps tuning.
PID tuning is necessary to have stable temperatures.
The stock heat cartridge and termistor can be mounted on the E3D heat block.
The printable area is maintained to 220x220, but the printing results shifted near 5-6mm right. You can have all of your printing area back with Pronterface and the command M206 X10 (or X6) and M500 to store permanently.
Y axis doesn't need any change.
It's impressive how good prints this inexpensive upgrade.
Here you can buy it:
Now my printer is an Enderoon.
