Radiator Booster fan holder with magnets for 140mm inner width
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modular Radiator Booster and fan holder with magnets for 140mm inner width and 120 mm fan.
- Ocena
- 0 / 5
- Polubienia
- 61
- Pobrania
- 310
- Wydruki
- 1
- Wyświetlenia
- 3192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
There are many radiator boosters. This one is for radiators with 140 mm inner width and 120 mm fans. You can use up to 4 radiators.
The booster consists of two components:
- controller holder (need 1 print)
- fan holder (need 1 to 4 prints)
For the controller I use this one (thanks to @ecsv) https://www.printables.com/de/model/498208-wemos-d1-mini-heater-fan-controller Chose “top_70mm.stl” to have a little bit more flexibility connecting the plugs to the pcb than in my photos.
The components are attached to each other with short filament pieces.
The holder is attached to the radiator with 10x2 mm or 10x3 mm magnets.
The fans can be screwed to the holder. For noise reduction I use rubber pins.
Additional components needed:
For each fan holder:
- 1x 120 mm fan
- 4x fan screw or rubber pin
- 6x 10x2 mm or 4x 10x3 mm magnet
For controller holder:
- 4x fan screw
- mentioned parts from https://www.printables.com/de/model/498208-wemos-d1-mini-heater-fan-controller
- 4x 10x2 mm or 4x 10x3 mm magnet
Remark: The system has not been testet under real conditions yet because it was build in summer :-). ==> Edit 2nd year/winter of use: Works very well.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
15% Gyroid
Filament material:
PLA
