1 / 4
Simple Floor Sweeper (+TPU)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple floor sweeper (Swiffer) with TPU grabbers. Can be used with things like dryer sheets or old rags. (2 sizes)
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 658
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (28)Powiązane
A simple floor sweeper (Swiffer) with TPU attachment wipes. Can be used with whatever fits like dryer sheets or old rags. There is a small (140x125mm) and wide (180x125mm) version.
This file uses the pole attachment parts from the Dryer Sheet Swiffer by Julius 3E8. Download them from there and give them a LIKE. Supporters can also export them from the source file.
Print/Assembly Directions:
- Print all parts from any hard filament, then assemble with your sweeper pole. The attachment parts include a two-sided spring detent.
- In my case, there was only one hole, so I drilled through and hammered in a 5mm pin.
- Print the attachment wipes in TPU, them push into place with the flaps facing up.
Changes to original file:
- Sweeper is a single piece instead of top/bottom.
- Sweeper is rounded on corners and sloped on the bottom to reduce friction and bumps.
- Bottom of sweeper has cutouts to reduce warping and make removal from the print surface easier.