1 / 4
Simple Floor Sweeper (+TPU)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple floor sweeper (Swiffer) with TPU grabbers. Can be used with things like dryer sheets or old rags. (2 sizes)
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 95
- Makes
- 0
- Views
- 658
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
A simple floor sweeper (Swiffer) with TPU attachment wipes. Can be used with whatever fits like dryer sheets or old rags. There is a small (140x125mm) and wide (180x125mm) version.
This file uses the pole attachment parts from the Dryer Sheet Swiffer by Julius 3E8. Download them from there and give them a LIKE. Supporters can also export them from the source file.
Print/Assembly Directions:
- Print all parts from any hard filament, then assemble with your sweeper pole. The attachment parts include a two-sided spring detent.
- In my case, there was only one hole, so I drilled through and hammered in a 5mm pin.
- Print the attachment wipes in TPU, them push into place with the flaps facing up.
Changes to original file:
- Sweeper is a single piece instead of top/bottom.
- Sweeper is rounded on corners and sloped on the bottom to reduce friction and bumps.
- Bottom of sweeper has cutouts to reduce warping and make removal from the print surface easier.