40x20 Pipe Leveling Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Leveling feet for anything based on 40x20 rectangular pipe.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 430
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Recently I built a table with legs from 40x20 tubing. And I found out, that my floor isn't really flat, so I needed some leveling feets to level the tabletop and make the table stand still.
Minimum height of the feet is 32mm, maximum is 46mm.
There is a two versions of the top part - one has a 4mm hole to be screwed to pipe, another one designed to just be a stand.
I have a pretty heavy table, so I printed mine with 80% infill. Feel free to experiment according to your needs.
My top parts were printed with supports, with threaded side up.
Thread joint is tight in original model, so I printed my bases with Horizontal Scaling Factor Shrinkage Compensation at 98%, to make it a bit smaller. But, of course, you always can try to force it in place or do some post process.