E3Dv6 compact - 40mm Fan Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A ring fan duct for the "E3D v6 Compact Extruder for i3 Rework" by Mak-a-face
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 219
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A ring fan duct for the "E3D v6 Compact Extruder for i3 Rework" by Mak-a-face.
The original Duct ist very good for airflow, but due to the one sided cooling, corners stand up and overhangs, that are not to the right side, don't look good.
This design removes the problems above and gives nice and even airflow, thanks to the ring.
This part should be printed with ABS or any other high temperature material.
If you use PLA, you should cover the inside of the ring with Kapton Tape.
This design has a lot of bridges, a FAN is NEEDED!
Print Settings
Printer:
Custom RepRap
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Notes:
Support Settings: (i used Cura)
Placement: Touching Buildplate
Overhang Angle: 80°
Pattern: Zig Zag
Connect Support ZigZags: Yes
Densitiy: 15%
Use Towers: No
Category: 3D Printer Parts