1 / 5
TP-Link SG105E 10" Rack mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Little remix to mount a TL-SG105E in your 10" Rack. You have to remove the two little screws under the switch. After that you have to slide the switch in the mount until its flush with the front. The last step is adding two M3x6mm screws in the original holes and thighten them up.
You should print it like you see it in my last picture. Face down, a 45 degree angle and without supports.
You need:
2x M3x6mm SHCS or BHCS (should not be longer than 6mm)
Give this design a like and share your makes. Thank you!