1 / 2
Ratrig Foot
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model increases the distance from the V-Core 3.1 by an additional 80cm so that a cleaning robot can fit underneath.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 449
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
- Remove feet with Joining Plate for 3030 - 90 Degree (preferably each foot separately).
- Reuse M5 and M6 screws and insert a M5 Hex Locking Nut through the largest hole in the intended stall.
- Fix the Rubber foot with metal insert with M5 screw from the other side (fix it with a blunt object if it sits not tight enough).
- Joining Plate for 3030 - 90 Degree place on the 3D print M6 Cap head Screw through the holes and fix from the opposite side with a M6 drop In T-slot
- Attach to the ratchet and repeat for all other feet.
Information: make sure your 3D printer prints as accurately as possible because I didn't leave much wiggle room with the M5 Hex Locking Nut.