Ikea Adils 40mm support bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Not technically a remix since I completely redesigned this using Fusion360. Although to be fair, it was fully inspired…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 241
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Not technically a remix since I completely redesigned this using Fusion360. Although to be fair, it was fully inspired by https://www.thingiverse.com/thing:1656880, so I'll give remix credit.
I wanted something I could use to support the four legs of a table, not add a shelf, so I added a 90deg support tab. Print four (one for each leg), screw clamp them so they don't rotate (should be plenty, doesn't have to be crazy tight), then wood screws into the cross supports.
- I'm using a 1x2 for the cross supports
- The clamp holes are 3.5mm, I use an M3 x 16mm with washers, lock washer, & nut
- The base mount holes are 5mm and sized for a #8 wood screw, 3/4"
Print Settings
Printer Brand:
Anycubic
Printer:
Photon Mono_x_6k
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.05mm layers (50 microns)
Infill:
n/a
Filament: 25% Tenacious, 75% Elegoo Standard Resin Black
Notes:
Prints great without supports on my Mono X 6k, no reason to believe it won't print equally as well on an FDM printer.
Designed from scratch using Fusion360. Heavily inspired by https://www.thingiverse.com/thing:1656880, so giving full remix credit.
Category: Organization