Parametric Phone Mount for Fanatec Virtual Dashboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Phone holder to be used as a sim dash. Height adjustable and removable without tools
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 376
- Wydruki
- 2
- Wyświetlenia
- 3615
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Phone holder for Sim Racing Dashboard. Fits Fanatec accessory mount.
Height adjustable for different wheels (Tested with WRC and Mclaren GT3). Spring mechanism means quick adjustments and easy removal when you need the phone - simply slides off. The bracket that stays fixed to the wheel does not extend above the top of the CSL DD wheel base so it can be left on when not in use.
Model is parametric so can be adjusted within reason to fit other phones. Width and Height are the extreme measurements with a case if required. Depth is the depth before the clamp bits overhang the phone. Due to the curved edges of my phone I took a couple mm off and found it fit better.
The static model files are for an iPhone 11 with case (155w x 80h x 9d)
The model needs approximately the right aspect ratio for a phone, it will break if you try to adjust measurements in large steps. Adjust width and height by a couple mm at a time alternating between the two and it'll be OK.
You'll need 2x M6x20mm cap head bolts
Print Settings:
Use PLA for the bracket that bolts to the wheelbase
Use PETG for the phone holder as it needs to flex to ‘snap in’ the phone. PLA will work but it's a bit sketchy. Use concentric top and bottom layers
Print the phone holder with supports or the spring might fuse. It's a bit fiddly to remove them but they'll come out if you pull them towards the bottom of the phone holder (along the direction of the channels)