snips / plier holder

After recently tidying up the area I came up with this basic design to keep the pliers / snips / cutters closed together so I could store them away easier and being quite clumsy not slice myself up with them haha.

I am relatively new to design so this is mainly for me to practise and learn so any feedback is most welcome please post your prints / comments below so I can improve and see my designs being used :)

Print Settings:
Supports: None required
Infill: 10-15%
Walls / Perimeters: 3
Fill Pattern: Grid / Cubic or any other to be honest
Print Time: 11 Minutes
Layer Height: 0.28mm - 0.10mm
Nozzle: 0.4mm - likely work with any others :)

Should be no requirement for a brim / skirt however if you have poor adhesion it might be worth sticking a brim on as they are small prints, i printed these flat to the bed however you could stand them up also.

Curved variant dimensions:
49.838mm interior width
10.839mm interior height

62.907mm exterior width
19.500mm exterior height

Square variant dimensions:
49.838mm interior width
10.839mm interior height

58.319mm exterior width
19.500mm exterior height