snips / plier holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made to close the pliers / snips / cutters together for better storage when not using them.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 30
- Makes
- 0
- Views
- 181
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
After recently tidying up the area I came up with this basic design to keep the pliers / snips / cutters closed together so I could store them away easier and being quite clumsy not slice myself up with them haha.
I am relatively new to design so this is mainly for me to practise and learn so any feedback is most welcome please post your prints / comments below so I can improve and see my designs being used :)
Print Settings:
Supports: None required
Infill: 10-15%
Walls / Perimeters: 3
Fill Pattern: Grid / Cubic or any other to be honest
Print Time: 11 Minutes
Layer Height: 0.28mm - 0.10mm
Nozzle: 0.4mm - likely work with any others :)
Should be no requirement for a brim / skirt however if you have poor adhesion it might be worth sticking a brim on as they are small prints, i printed these flat to the bed however you could stand them up also.
Curved variant dimensions:
49.838mm interior width
10.839mm interior height
62.907mm exterior width
19.500mm exterior height
Square variant dimensions:
49.838mm interior width
10.839mm interior height
58.319mm exterior width
19.500mm exterior height