Model Rocket Ignition Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
prints assembled and in place with no supports. For use with one 9v battery.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 189
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This launch ignition box is for model rockets. It prints assembled and in place with no supports. For use with one 9v battery. The case has a freely moving switch cover to protect from accidental discharge. The case has a sliding panel to ease access and change out the battery.
You will need a 9v battery, momentary switch (normally open), 9v battery clip, and a length of bell wire (or similar). The hole for the momentary switch is 7mm in diameter. Modify or drill out to accommodate for larger/smaller switch you may purchase. All parts, except the battery, should run you less than a couple dollars.
Instructions: Print with 0.3mm thickness or less. I used 0.3mm and it printed fine. Print with an infill between 15% and 25%.
The slide cover location of the main file has integrated supports so remove them prior to installing the slide cover. Installing the switch is a little tricky, but be sure to wire everything first.
ALWAYS LAUNCH MODEL ROCKETS IN A SAFE AND OPEN AREA.
HAVE FUN.
This is my original design. It is not reuploaded from another website; however, is was originally posted to Thingiverse: https://www.thingiverse.com/thing:373311