Bambulab filament upgraded drying cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This cover will gather the heat from the whole print bed and concentrate until the top of the spools you want to dry.
- Ocena
- 5 / 5
- Polubienia
- 45
- Pobrania
- 116
- Wydruki
- 2
- Wyświetlenia
- 1944
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Presentation
This model will allow you to use the heat generated by the whole print bed when using your bambulab printer to dry some rolls of filament.
Parametric model
The Fusion 360 file (.f3d) is parametric. Right now I've used a large base so it takes as much as possible of the bed, but it overhangs a little bit. You can reduce that, you can also adjust the inner diameter of the top section, the magnets' dimensions, etc.
Right now the top is 220mm in diameter … plus over-thickness or misplaced magnets. Also, the magnets I have are 6mm x 1.65mm … The holes for the magnets are 6.4mm x 2.2mm (I used a bit of hot glue to keep them in place … edit: that was stupid, magnets just fell off due to the temperature. Use super glue instead)
Printing recommendations
I have printed it with my Bambulab X1 Carbon and sliced it with bambu studio.
The filament was PETG (so it is more resistant to heat than PLA)
I recommend using all default parameters in silent mode (50% speed), increasing the aux fan speed. By doing that, I had good results without any support.
Using normal speed gave me a bit of stringing in the overhang area. Changing the sparse infill pattern to gyroid also gave me some "gumming up" problems.
What's next ?
right now I'll use it with some carton box cover, but I will create a printable lid with some holes. I'm also considering some high lid so I can stack 2 or 3 spools.
If you feel generous …
https://www.buymeacoffee.com/chrisprols1980 (minimum lowered to 1€)