Tiny Travel Screwdriver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sometimes, just one screw (maybe a few) to unscrew or tighten makes all the difference in the world...
- Ocena
- 4,818 / 5
- Polubienia
- 979
- Pobrania
- 1428
- Wydruki
- 28
- Wyświetlenia
- 9515
- Oceny
- 22
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
What it is
A tiny screwdriver, storing seven 4mm Micro Bits (28mm in length) and attachable to a keyring or string on your gear. → Be prepared for that single or few screws that casually pop up, trying to ruin your day.
The forces induced by the applied torque are spread over a large area by the stored bits, stripping a screw is no problem with this design.
How to print
Recommended for printing is a 0.2 mm layer height and a 0.4mm nozzle or finer. The version in the pictures is printed with these settings in PETG. With that material adequate cooling is advised, I simply printed a set of two to give the small layers enought time to cool.
- My 4mm bits varied quite a bit depending on the vendor, some scaling may be required to get a nice fit (100% to 103% is reported back so far).
- If your bits are noticeably shorter or longer than 28mm, you may have 25mm or 30mm long variants. Use the provided alternate parts in that case.
- If your bits are rattling lengthwise, there are optional cushioning pads available to eliminate that (TPU advised). → Scale them first solely in the z direction to your needs (1 mm by default), after that scale them only in xy as the rest of the model is scaled. [Thanks to @TheCafeRacer for the feedback.]
What next
There may be improvements, modifications and deletions based on feedback given here.
Maybe, take a look at my other designs ;-)