1 / 1
Silica Gel Container Lid with Hygrometer - with added spacing and barrier — zdjęcie 1

Silica Gel Container Lid with Hygrometer - with added spacing and barrier

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A modified version of the original hygrometer lid, with a barrier and some distance to the hygrometer

Ocena
5 / 5
Polubienia
5
Pobrania
51
Wydruki
1
Wyświetlenia
393
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Each time I take out a spool of filament and forget it has one of the silica containers in it, I drop it, the hygrometer will pop out and silica gel will be spilled in each ever-so-small crevice of my floor.

This is my attempt at fixing this by adding a small barrier similar to the floor of the container between the hygrometer and the silica gel. The barrier is deliberately designed a bit weird so that slicers will create a good anchor for the bridge.

Development Notes

The original thread was hard to copy, so I tried to approximate it as good as possible:

  • Original outer diameter is ~44.87mm
  • Thread Angle is ~69.5° (careful, that's non-ANSI and non-ISO)
  • Root factor ~ 0.08431, Tip Factor ~0.271662763
  • Thread Pitch is: 4.27mm

This lid uses a 45mm x 4.27mm Thread with a 69.5° angle. I've increased the Tip Factor to 0.35 and decreased the root factor to 0.05 and added an internal offset of 0.1mm so the threads fit together nicely.

Tagi