Silica Gel Container Lid with Hygrometer - with added spacing and barrier
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A modified version of the original hygrometer lid, with a barrier and some distance to the hygrometer
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 51
- Makes
- 1
- Views
- 393
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Each time I take out a spool of filament and forget it has one of the silica containers in it, I drop it, the hygrometer will pop out and silica gel will be spilled in each ever-so-small crevice of my floor.
This is my attempt at fixing this by adding a small barrier similar to the floor of the container between the hygrometer and the silica gel. The barrier is deliberately designed a bit weird so that slicers will create a good anchor for the bridge.
Development Notes
The original thread was hard to copy, so I tried to approximate it as good as possible:
- Original outer diameter is ~44.87mm
- Thread Angle is ~69.5° (careful, that's non-ANSI and non-ISO)
- Root factor ~ 0.08431, Tip Factor ~0.271662763
- Thread Pitch is: 4.27mm
This lid uses a 45mm x 4.27mm Thread with a 69.5° angle. I've increased the Tip Factor to 0.35 and decreased the root factor to 0.05 and added an internal offset of 0.1mm so the threads fit together nicely.