Peugeot Pepper Mill Funnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pepper mill / grinder funnel that fits a bit better for those Peugeot pepper mills with 6mm stems and 30mm opening
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Why this Remix?
As original author mentioned, every pepper mill / pepper grinder is a bit different and even though they did include a model for a Peugeot pepper mill, it was a little too narrow for my model of Peugeot grinder.
Mine has approximately a 30mm opening so I widened the base a few millimeters for a better fit. Also the original had a 6mm “hole” (which is the same size as my grinder's stem) but when printed, it ended up a tad small at a measured 5.85mm. So I expanded the opening in this remix ever so slightly so the stem doesn't “stretch” the “hole” when putting the funnel in.
So if your Peugeot pepper mill / pepper grinder looks like mine and/or the opening measures about 30mm, then this remix should fit a bit better.
Printing Notes
Make sure you print it wide side down for stability.
I also added an outside brim (5mm wide, 0.11mm gap) for extra stability.
This does require supports but they are very easily removed.
I printed mine in PolyLite PETG with 3 perimeters.
Seems very strong. With three perimeters there is almost no actual infill so you can go high on the infill without actually using any noticeable extra filament.