Peugeot Pepper Mill Funnel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Pepper mill / grinder funnel that fits a bit better for those Peugeot pepper mills with 6mm stems and 30mm opening
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 36
- Makes
- 0
- Views
- 212
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Why this Remix?
As original author mentioned, every pepper mill / pepper grinder is a bit different and even though they did include a model for a Peugeot pepper mill, it was a little too narrow for my model of Peugeot grinder.
Mine has approximately a 30mm opening so I widened the base a few millimeters for a better fit. Also the original had a 6mm “hole” (which is the same size as my grinder's stem) but when printed, it ended up a tad small at a measured 5.85mm. So I expanded the opening in this remix ever so slightly so the stem doesn't “stretch” the “hole” when putting the funnel in.
So if your Peugeot pepper mill / pepper grinder looks like mine and/or the opening measures about 30mm, then this remix should fit a bit better.
Printing Notes
Make sure you print it wide side down for stability.
I also added an outside brim (5mm wide, 0.11mm gap) for extra stability.
This does require supports but they are very easily removed.
I printed mine in PolyLite PETG with 3 perimeters.
Seems very strong. With three perimeters there is almost no actual infill so you can go high on the infill without actually using any noticeable extra filament.