Cable organiser for LASER sculpfun S30
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The cable and compressor pipe was not solved good by default. This solution improves cable grip at LASER head.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 150
- Wydruki
- 1
- Wyświetlenia
- 1116
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
The printed object can be easily clicked and also easily removed. Manufacturer uses a plastic tape.
It is recomended to use small 0.25mm nozzle. Object has fine details. I have tested 0.4mm nozzle and results were not so good.
Note 1.4.2024: Cableholder v2. has a little bit more stronger grips. Variable layer makes 3 times faster print. 0.1mm is used only for grips.
Note: Cable clip sometimes crack. It is possible not only to click it but also move to hole from down to up.
Note 25.10.2024: CableHolderSF3 v3. has cable clip 2mm heightened. Need to use supports.