ESR HaloLock Kickstand Desk Phone Stand Magsafe
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a stand for the ESR HaloLock Kickstand. Compatible with Standby mode.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 855
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Standard Digital File License
Does not work for the 15/15 Pro, but works for the max and should work for the plus
Updated 9/28/2023
Ultra slim holder versions were added for ABS tolerances (Untested)
Updated 9/27/2023
There are new versions of the models with improved tolerances for printing in ABS.
Tolerances with PETG were not tested.
This is designed to work with this charger. There are four versions, two are for a desk and two for the wall. These were tested with an iPhone 13 Pro Max
Printing instructions:
- Print in the orientation the model comes in
- print at a 0.16mm layer height
- print with organic/tree supports everywhere min branch diameter of 6 and min double wall branch diameter of 6
- Increase walls to 5 and infill to 25% w/ at high fan speed(no or little cooling results in poor print quality and ruins the tolerances)
- ABS is recommended, tolerances loosen with PLA/PETG due to the heat generated by the charger. If you use PLA, I recommend a dot of glue or something to keep the charger from falling out of the stand.
- Tolerances were tested with white Polymaker PolyLite ABS
I don't recommend printing it in PLA/PETG but the files are there with the appropriate tolerances for a snug fit.