VCORE3.1 printed part improvements and additions
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here are some mods I made to a few vcore3.1 printed parts that I found were better than the originals.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 281
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The enc2 bowden clamp extended is extended out from the enclosure for better alignment with the filament spool. It uses a 5mmx 50 bolt and 5mm 3030 tnut for mounting.
The enc2 spoolholder 3mm mod gives more space from the hardware on the frame to avoid it catching on the filament spool and causing jams. (This is for 3mm thick panels.)
The vcore3 dc regulator mount is for mounting a dc regulator for powering the raspberry pi. This is an original design, not a remix. The regulator it is intended for: https://www.amazon.com/dp/B085T73CSD?psc=1&ref=ppx_yo2ov_dt_b_product_details
The lead screw motor cage trim front and rear were made wider to allow for better coverage of the panel cutouts. These are for 3mm thick panels.
The IEC 3030 print was modified to work better with this switch/power input device: https://www.amazon.com/button-Adapter-Connector-Socket-MXRS/dp/B082ZFRV1B/ref=sr_1_15?crid=2KJ2AA9J8ABU1&keywords=iec&qid=1695645547&sprefix=iec%2Caps%2C104&sr=8-15
I also include the step files if you want to modify further.